When it comes to doing a siding job on your home, you might not think of roof and fascia installation right away. However, installing a siding on your home can be very complex, as it involves cutting, sawing, nailing and stapling a sheet of metal together in several different configurations. Plus, you have to make sure that the pieces of metal you use for the project are galvanized and will stay in good condition once they are installed. You also need to make sure that you have enough of them so that you have plenty of boards to use. Learn more about this product in this website. To start, you have to get out your measuring tapes and measure the exact location of where you want the fascia to go. The best spot is where your house faces south, so that all of the nails will hit at exactly even angles. Cut the sheet metal in this area to just a couple inches longer than the size of your window. Use the nippers that come with the screws to cut the material to the proper length. You may want to wear some safety glasses, or even a mask, as these pieces of metal are extremely sharp and you can damage your eyes if you aren't wearing anything at all. Use the aluminum nails that are supplied with the screws to anchor each nail to the studs that are located on the top and bottom of the soffit or fascia. You want to stagger the pieces of metal so that you have plenty of room to work. If you have enough coffins, you can place three or four on either side of each other. Using the nails, screw them into the siding on both sides, starting from the bottom of the wall. For the fascia boards, place one board on top of each soffit and then install the next one. Keep installing until you reach the last one, which should be the top of the roof. Start by nailing each piece of wood to the soffit and fascia boards as you proceed. This will provide a fascia installation firm for the fascia and give you room to work. When you get to the rafters, use an extension depending on the length of the rafter, and screw them into place as you go. When installing the screws into the rafters, use wood shims under them to make sure they are straight. Once you are sure that you have them lined up correctly, fasten them with screws. You can install all of this quickly and easily, using steel wool or aluminum nails, but if time is limited, you can use nails of the same size and shape of the fascia boards. After installing the edges, use a hammer to a nail in the j-channel along the edges. Use wood shims under the nails to make sure they are straight. You can sand the edges slightly after you have finished nailing in the j-channel to get a smooth edge. Now it is time to install the pieces of wood that will make up the roof. Nail the bottom edge of the first piece of wood to the first rafter you just finished nailing, and then use the shims to ensure that the nails line up. Finish nailing in the corners, using the same wood shims, and then install the rafters. Use an angle grinder to cut away excess aluminum or steel from the front and back of the rafters as they are being installed so that you have a flat surface to install the fascia and trimmings. Trim the trims flush with the edge of the fascia. Finishing off the project by nailing the trim to the fascia and then to the edge of the roof, and then gracing it with aluminum or steel gutters. Here is an alternative post for more info on the topic: https://en.wikipedia.org/wiki/Fascia.
0 Comments
Leave a Reply. |